Brake-Lock Adjustment - Suzuki AN650 2002 Service Manual

9-84 CHASSIS
When remounting the brake master cylinder onto the handle-
bars, align the master cylinder holder's mating surface A with
the punch mark B on the handlebars and tighten the upper bolt
7 first.
Master cylinder mounting bolt:
• After touching the brake hose union pipe to the stopper,
tighten the brake hose union bolt to the specified torque.
Brake hose union bolt: 23 N·m (2.3 kgf-m, 16.5 lb-ft)
* The seal washers should be replaced with the new
ones to prevent fluid leakage.
* Bleed air from the system after reassembling the
master cylinder. (

BRAKE-LOCK ADJUSTMENT

Before adjusting the brake-lock, perform to bleed the air from
the rear brake system.
• Pull the brake-lock lever by one step (one notch).
NOTE:
* The brake-lock lever has eight steps (eight notches) when pull-
ing in full.
* When pulling the brake-lock lever, first the brake-lock switch
makes sound, then notch makes a sound. Make a count of
notch by sound except the brake-lock switch's sound.
• Loosen the locknut 1 and the adjust bolt 2.
10 N·m (1.0 kgf-m, 7.0 lb-ft)
2-25)