Suzuki AN650 2002 Service Manual page 317

• Tighten the handlebar clamp bolt to the specified torque.
Handlebar clamp bolt: 23 N·m (2.3 kgf-m, 16.5 lb-ft)
NOTE:
When tightening the handlebar clamp bolts, first tighten the bolts
1 and then tighten the bolts 2.
• Install the left switch box 3 to the handlebars by engaging the
stopper D with the hole E on the handlebars.
• Install the rear brake master cylinder. (
• Install the right switch box 4 to the handlebars by engaging
the stopper F with the hole G on the handlebars.
• Install the front brake master cylinder. (
• Install the handlebar covers and inspect the handlebar cover
clearance. ( 9-24)
9-84)
9-72)
CHASSIS 9-45