• Set the bearings installed in the special tool to the crankcase
half as shown.
* Be sure the bearing protruded side A faces the
crankcase bore.
* Align the special tool mating surface with the line
mark B on the crankcase.
• Apply enough engine oil to the special tool and the bearings
and then set the special tool carefully.
• Gradually press in the bearing into the main journal bore by
using the hand-press until the special tool 1 or 2 stops the
special tool 3.
1 09913-60210: Journal bearing remover/installer
2 09913-60230: Journal bearing remover/installer
3 09913-60241: Journal bearing installer holder
Hand press
or
Since the journal bearing press-fitting position is dif-
ferent between the right and left crankcases, use the
correct installer respectively.
(Left crankcase)
(Right crankcase)
Bearing
ENGINE
Left crankcase
Right crankcase
or
Bearing
3-53