Suzuki AN650 2002 Service Manual page 316

9-44 CHASSIS
• Apply grease to the bearings, dust cover and dust seal.
• Install the upper bearing and the dust cover onto the frame.
99000-25010: SUZUKI SUPER GREASE "A"
STEERING STEM
• Tighten the steering stem nut to the specified torque with the
special tools.
09940-14911: Steering stem nut wrench
Steering stem nut: 45 N·m (4.5 kgf-m, 32.5 lb-ft)
• Turn the steering stem about five or six times to the left and
right so that the angular ball bearing will be seated properly.
• Loosen the steering stem nut by ¼ – ½ turn.
NOTE:
This adjustment will vary from motorcycle to motorcycle.
• Install the front fork to the steering stem lower bracket tempo-
rarily.
• Install the steering stem upper bracket 1.
• Tighten the steering stem head nut 2.
Steering stem head nut: 65 N·m (6.5 kgf-m, 47.0 lb-ft)
• Remount the front fork. (
HANDLEBARS
• Install the handlebars with the punch mark A on the handle-
bars aligned with the mating surface B of the handlebar
clamp.
NOTE:
Make sure that the dent C on the handlebar clamp faces for-
ward.
9-39)