Suzuki AN650 2002 Service Manual page 326

9-54 CHASSIS
DUST SEAL
• Install the new dust seal using the special tool.
09913-70210: Bearing installer set
• Apply SUZUKI SUPER GREASE "A" to the dust seal lips
before assembling rear wheel.
99000-25010: SUZUKI SUPER GREASE "A"
NOTE:
When installing the dust seals, the stamped mark of dust seal
must face the special tool.
REAR HUB DAMPER
• Install the rear hub damper into the rear wheel at a depth of
5.5 mm (0.22 in).
NOTE:
Apply soap water to the hub damper before installing the hub
damper in order to facilitate press fit.
BRAKE DISC
Make sure that the brake disc is clean and free of any greasy
matter.
• Apply THREAD LOCK SUPER "1360" to the disc bolts and
tighten them to the specified torque.
99000-32130: THREAD LOCK SUPER "1360"
Brake disc bolt: 23 N·m (2.3 kgf-m, 16.5 lb-ft)
REAR HUB DRIVEN JOINT
• Apply SUZUKI SUPER GREASE "A" to the O-ring and wheel.
99000-25010: SUZUKI SUPER GREASE "A"
• Install the O-ring to the rear wheel.
Replace the removed O-ring with a new one.
• Apply SUZUKI SUPER GREASE "A" to the rear hub driven
gear joint.
99000-25010: SUZUKI SUPER GREASE "A"
Rear wheel
5.5 mm (0.22 in)
Hub damper