Suzuki AN650 2002 Service Manual page 353

CALIPER
• Install the caliper.
• Tighten the caliper mounting bolts 1 to the specified torque.
Rear caliper mounting bolt: 26 N·m (2.6 kgf-m, 19.0 lb-ft)
• Connect the brake hose 2 to the caliper with the brake hose
union pipe seated in the cutaway on the caliper.
• Tighten the brake hose union bolt to the specified torque.
Brake hose union bolt: 23 N·m (2.3 kgf-m, 16.5 lb-ft)
* The seal washers should be replaced with the new
ones to prevent fluid leakage.
* Bleed air from the system after reassembling the cal-
iper. ( 2-25)
* Brake fluid, if it leaks, will interfere with safe running
and discolor painted surfaces. Check the brake hose
and hose joints for cracks and fluid leakage.
BRAKE-LOCK
• Apply SUZUKI SILICONE GREASE to the brake-lock bolt end
A.
99000-25100: SUZUKI SILICONE GREASE
• Install the new gasket and the brake-lock housing to the cali-
per.
• Apply THREAD LOCK SUPER "1360" to the brake-lock bolts.
99000-32130: THREAD LOCK SUPER "1360"
• Tighten the brake-lock housing bolts to the specified torque.
Brake-lock housing bolt: 23 N·m (2.3 kgf-m, 16.5 lb-ft)
• Apply SUZUKI SILICONE GREASE to the O-ring.
99000-25100: SUZUKI SILICONE GREASE
• Install the O-ring into the brake-lock housing.
Replace the gasket and O-ring with new ones.
CHASSIS 9-81