CALIPER HOLDER
Inspect the brake holder sliding pins for wear and other damage.
If any damage is found, replace the sliding pin with a new one.
BOOT
Inspect the boots for damage and wear. If any damage is found,
replace boots with new ones.
CALIPER REASSEMBLY AND REMOUNTING
Reassemble and remount the caliper in the reverse order of
removal and disassembly. Pay attention to the following points:
* Wash the caliper components with fresh brake fluid
before reassembly. Never use cleaning solvent or
gasoline to wash them.
* Apply brake fluid to the caliper bore and piston to be
inserted into the bore.
Specification and Classification: DOT 4
PISTON SEAL
• Install the piston seals as shown in the right illustration.
• Install the pistons to the caliper.
CHASSIS
9-79