Suzuki AN650 2002 Service Manual page 344

9-72 CHASSIS
• Apply brake fluid to the piston and cups.
• Install the following parts to the master cylinder.
1 Dust boot
2 Snap ring
3 Secondary cup
4 Piston
5 Primary cup
6 Return spring
• When remounting the brake master cylinder onto the handle-
bars, align the master cylinder holder's mating surface A with
punch mark B on the handlebars and tighten the upper bolt
7 first.
Front brake master cylinder mounting bolt:
• After touching the brake hose union to the stopper, tighten the
brake hose union bolt to the specified torque.
Brake hose union bolt: 23 N·m (2.3 kgf-m, 16.5 lb-ft)
* The seal washers should be replaced with the new
ones to prevent fluid leakage.
* Bleed air from the system after reassembling the
master cylinder. (
10 N·m (1.0 kgf-m, 7.0 lb-ft)
2-24)