Suzuki AN650 2002 Service Manual page 125

3-74 ENGINE
• Install the dowel pins.
• Install the camshaft holders and cam chain guide.
• Arrange the camshaft holder by hand so that it is positioned at
1 – 2 mm from the cylinder head mating surface.
• Tighten the camshaft holder bolts in ascending order of num-
bers as shown in the illustration.
Cam shaft holder bolt 1: 10 N·m (1.0 kgf-m, 0.7 lb-ft)
Cam shaft holder bolt 2: 10 N·m (1.0 kgf-m, 0.7 lb-ft)
NOTE:
Install the camshaft holder to the correct positions according to
the identification marks.
Intake camshaft: IN
Exhaust camshaft: EX
• Unlock the cam chain tension adjuster.
CYLINDER HEAD COVER
• Assemble the new gasket to the cylinder head cover.
• Coat the semicircular part of the gasket with sealing agent.
99000-31230: SUZUKI BOND "1216B"
1216
NOTE:
Do not remove the dowel pin at the backside of the cylinder
head cover since it is embedded.
• Install the cylinder head cover.
• Coat the both sides of the gasket washers 3 with engine oil
and tighten the head cover bolts.
Cylinder head cover bolt
Light tightening: 10 N·m (1.0 kgf-m, 7.0 lb-ft)
Final tightening: 14 N·m (1.4 kgf-m, 10.0 lb-ft)
1216