BATTERY
SPECIFICATIONS
Type designation
Capacity
a Anode plates
b Separator (fiberglass plate)
c Cathode plates
d Upper cover breather
INITIAL CHARGING
FILLING ELECTROLYTE
• Remove the aluminum tape 1 which seals the battery filler
holes 2.
• Remove the caps 3 from the electrolyte container.
NOTE:
* Do not remove or pierce the sealed areas 4 of the electrolyte
container.
* After completely filling the battery with electrolyte, use the caps
3 from the electrolyte container to seal the battery filler holes.
• Insert the nozzles of the electrolyte container 5 into the elec-
trolyte filler holes of the battery. Hold the electrolyte container
firmly so that it does not fall. Do not allow any of the electro-
lyte to spill.
• Make sure the air bubbles 1 rise to the top of each electrolyte
container and leave the electrolyte container in this position
for more than 20 minutes.
FTX14-BS
12V, 43.2 kC (12 Ah)/10HR
e Stopper
f Filter
g Terminal
h Safty valve
ELECTRICAL SYSTEM
10-37