Suzuki AN650 2002 Service Manual page 347

• Turn the piston 8 clockwise until it stops.
• Align the groove with line A by turning the piston out.
• Install the pad with the projection B fitted in the groove on the
piston.
• Install the pad to the caliper with the pad seated at the
hatched area C of pad spring.
• Tighten the pad mounting pins to the specified torque.
Pad mounting pin: 18 N·m (1.8 kgf-m, 13.0 lb-ft)
• Install the caliper.
• Tighten the caliper mounting bolt to the specified torque.
Caliper mounting bolt: 26 N·m (2.6 kgf-m, 19.0 lb-ft)
NOTE:
After replacing the brake pads, pump the brake lever several
times to check for proper brake operation and then check the
brake fluid level.
• Install the brake-lock cable. (
• Install the brake-lock arm with the punch mark D aligned with
punch mark E on the brake-lock shaft.
NOTE:
Make sure that the spring end faces to right side of the vehicle.
• Adjust the brake lock. (
9-86)
9-84)
CHASSIS 9-75