Protocol Menu - GRASS VALLEY Ignite SDC Series Instruction Manual

Protocol Menu

Ignite SDC/HDC Robotic Camera Instruction Manual
The PROTOCOL menu is shown in
described in Table 50.
CAUTION Changing the protocol to anything other than 4, will cause to camera block to
lose communication with the pan/tilt head, SHOT Director, and Ignite system.
If you lose communication, you must reset the protocol to 4 using the con-
trols and indicators on the back of the camera block.
Figure 70. PROTOCOL Menu
PROTOCOL **
**
PROTOCOL :1
Table 50. PROTOCOL Menu Selections
Selection
PROTOCOL [1 to 4]
Figure 70. Menu selections are
Description
For selecting the remote control communication system in accordance
with the system connected.
1: Information camera communication protocol (EIA422).
2: Information camera communication protocol (EIA232). For connecting a
PC.
3: Convertible PC control protocol (EIA422).
4: Convertible PC control protocol (EIA232). For connecting the pan/tilt
head (baud rate fixed at 9600 bps).
The protocol is actually switched after the power has been turned off and
back on.
Menu Selections
99