G/L, Color Bar Setting; Sharpness (Dtl) Setting Overview - GRASS VALLEY Ignite SDC Series Instruction Manual

G/L, Color Bar Setting

Sharpness (DTL) Setting Overview

Ignite SDC/HDC Robotic Camera Instruction Manual
Figure 21. GL, Color Bar Setting Submenu
Table 6. Color Bar Settings
Selection
H Phase
SC Coarse
SC Fine
Color Bar Set
Color Bar Set2
Figure 22. Sharpness (DTL) Settings Submenu
Table 7. Sharpness (DTL) Settings
Selection
DTL Select
Level
Noise Suppress
Description
(-206 to +49) Horizontal phase can be adjusted when a genlock signal is
supplied.
(1, 2, 3, 4) Coarse adjustment of sub carrier phase can be made when a
genlock signal is supplied.
(-511 to +511) Fine adjustment of sub carrier phase can be made when a
genlock signal is supplied.
(0.0 IRE, 7.5 IRE) The setup level of color bar can be adjusted.
(0.0 IRE, 7.5 IRE) Set 0.0 IRE for the SDI card.
Description
(Sharpness, Super DTL) If contour correction is not sufficient at the Sharp-
ness position when Detail Level setting is set to Low or High, select the
Super DTL position.
*Neither Sharpness nor Super DTL is valid for contour correction if Detail
Level setting is in the OFF position.
(OFF, Low, High) Detail level can be adjusted when Detail Select setting is
at Sharpness. Super DTL level can be adjusted when it is at Super DTL.
(OFF, Low, High) Screen noise can be reduced when Detail Level setting is
at High or Low.
Menu Selections
47