Initial Settings - GRASS VALLEY Ignite SDC Series Instruction Manual

Initial Settings

Ignite SDC/HDC Robotic Camera Instruction Manual
Table 29. Other Settings
Selection
Aspect Ratio
Fan SW
In case of the wrong setting in any use mode, take the following steps to
return to the initial settings.
1. Select [Initialize Data] on the main menu screen of each Use Mode.
Press the YES/ABC switch, then the [Initialize Data] screen
shows for about 10 seconds.
Figure 47. initialize Data Screen
2. Press the YES/ABC switch within about 10 seconds to return to the
initial settings (Table 30
initialized (Figure
Figure 48. Data Initialized Screen
3. If the NO/BAR switch is pressed, or if the YES/ABC switch is not
pressed, within about 10 seconds
main menu, then the existing settings are not initialized.
Description
Aspect ratio can be selected from 16:9 or 4:3.
OFF: Select this setting to stop the fan when its operating sound is found to
be bothersome in a studio or other such environment.
Auto: The temperature is detected automatically, and the fan starts operat-
ing when the temperature exceeds approx. 95 ºF (35 ºC)
and Table 31), the existing settings are
48), and the camera returns to main menu.
(Figure
Menu Selections
(Figure
49), and the camera returns to
47)
75