Other Settings - GRASS VALLEY Ignite SDC Series Instruction Manual

Other Settings

Ignite SDC/HDC Robotic Camera Instruction Manual
Table 13. Color matrix Settings
Selection
YI Phase
YI_G Gain
YI_G Phase
G Gain
G Phase
G_Cy Gain
G_Cy Phase
Cy Gain
Cy Phase
Cy_B Gain
Cy_B Phase
B Gain
B Phase
Figure 29. Other Settings Submenu
Table 14. Other Settings
Selection
Gamma
Knee Point
White Clip
Flare R/G/B
Black Stretch
Clean DNR
Field/Frame
Baud Rate
Component
Description
Varies the hue of the yellow.
Increases or decreases the intermediate color between yellow and green.
Varies the hue of the intermediate color between yellow and green.
Increases or decreases the green.
Varies the hue of the green.
Increases or decreases the intermediate color between green and cyan.
Varies the hue of the intermediate color between green and cyan.
Increases or decreases the cyan.
Varies the hue of the cyan.
Increases or decreases the intermediate color between cyan and blue.
Varies the hue of the intermediate color between cyan and blue.
Increase or decreases the intermediate color between blue and magenta.
Varies the hue of the intermediate color between blue and magenta.
Description
(0.35 to 0.55) Gamma correction level can be set.
88% to 98%: The level of video signals subject to knee (knee point) can be
set. Dynamic: Knee level is automatically adjusted according to the scene.
(95% to 110%) The peak level of video signals to be white-clipped can be
set.
(0 to 100) Flare correction level can be adjusted.
Black stretch to correct the suppression of black portions at low luminance
can be set to ON or OFF.
(OFF, Low, High) This enables the clean DNR effect to be selected.
Field: CCD storage will be by field storage.
Frame 1: Vertical resolution increases in frame storage.
Frame 2: Vertical resolution is raised without increasing residual images
by frame storage and electronic shutter.
(1200bps, 2400bps, 4800bps, 9600bps) This setting is to select a com-
munication speed in controlling the camera from the computer.
This enables RGB, Y/Pr/Pb or Y/C to be selected as the component signals
which are to be output from the I/F REMOTE connector.
Menu Selections
55