Prompter (Optional); Power - GRASS VALLEY Ignite SDC Series Instruction Manual

Section 2 — Installation

Prompter (Optional)

Power

32
2. Connect an SDI video cable (not supplied) from the camera block to a
studio monitor or video switcher (with studio monitor output).
3. If using a video switcher, connect genlock to the camera block.
4. Connect the Iris control cable from the lens assembly to the camera
block.
5. Connect the unterminated tally wires from the camera block to a tally
controller using 16AWG wire, or provide contact closure control. Tally
control wiring should not exceed 200' (60.96 m).
1. Connect a VGA video cable (not supplied) between the prompter and
the script generator.
2. Attach the prompter tally optical sensor to the camera block tally light
cover.
1. Connect the 48 V dc power cord to the pan/tilt head assembly
(Amphenol circular) and the 48 V dc power supply (DIN8). Then
connect the power supply to Mains power.
2. Attach the Mains power cord to the prompter.
Ignite SDC/HDC Robotic Camera Instruction Manual