Prompter (Optional) - GRASS VALLEY Ignite SDC Series Instruction Manual

Prompter (Optional)

Ignite SDC/HDC Robotic Camera Instruction Manual
1. Slide extrusion slots onto mounting plate rods and rotate rods to
tighten (Figure 10). Mounting plate rods slide into the back of the
extrusion where two slots provide alternative vertical positions for the
prompter. The rods attach to the extrusion using a T-bolt that is
tightened by turning the rod.
Figure 10. Extrusion
2. Rotate the drop plates to the orientation shown in
Figure 11. Drop Plates
3. Attach drop plates to extrusion and tighten red fixing screws. A choice
of mounting holes are provided to raise and lower the monitor in
relation to the hood to prevent the outer edge of the TFT screen from
appearing in the shot.
4. Attach the hood to the extrusion and rotate hood columns to tighten.
5. Move prompter unit back on the support rods until the lens is nearly
touching the glass and lock in position with small locking levers.
6. Slide the whole prompter assembly back on the mounting plate rods to
obtain best possible balance of the pan/tilt L-bracket. Attach
counterweights if necessary.
Installation Procedures
Figure 11.
29