Super Gain Menu - GRASS VALLEY Ignite SDC Series Instruction Manual

Appendix C — HD Camera Block

Super Gain Menu

90
The SUPER GAIN menu is shown in
described in Table 42.
Figure 61. SUPER GAIN Menu
S. GAIN (1/2) S. GAIN1
** **
MODE :S. GAIN1
*
TOTAL GAIN :42dB
GAIN :30dB
PIX MIX :+6dB
V MIX :+6dB
FRAME MIX :OFF
H DETAIL LEVEL :1
CRISP :00
LEVEL DEPENDENT :5
PEAK FREQUENCY :2
Note These settings are performed when S.GAIN1, S.GAIN2 or S.GAIN3 has been
selected by GAIN SELECT.
Table 42. SUPER GAIN Menu Selections
Selection
MODE
[S.GAIN1, S.GAIN2, S.GAIN3]
TOTAL GAIN [0 dB to 72 dB]
GAIN [0 dB to 36 dB]
PIX MIX [OFF, +6 dB]
V MIX [OFF, +6 dB]
FRAME MIX
[OFF, +6 dB to +24 dB]
H DETAIL LEVEL [00 to 63]
CRISP [00 to 31]
LEVEL DEPENDENT [0 to 15]
PEAK FREQUENCY [0 to 31]
M GAMMA
[0.35 to 0.75 (DRS OFF)]
[–10 to +10 (DRS ON)]
M PED OFFSET [–200 to +200]
R PED OFFSET [–200 to +200]
B PED OFFSET [–200 to +200]
Figure 61. Menu selections are
** S. GAIN (2/2) **
M GAMMA
M PED OFFSET
R PED OFFSET
B PED OFFSET
Description
For selecting the S.GAIN storage table.
For displaying the total gain for GAIN, PIX MIX, V MIX and FRAME MIX.
For setting the gain increase.
For setting the addition of horizontal pixels ON or OFF.
For setting the addition of vertical pixels ON or OFF.
For setting the gain increase based on accumulation in the CCD image
sensor. This setting does not take effect when MENU SEL is set to FILM
MENU and the 720/60p or 720/59.94p is selected as the FORMAT setting.
For setting the H DETAIL level.
For setting the noise elimination level of the detail signals.
For removing the detail in the dark areas. The higher the number set, the
wider the range in which the detail is removed.
For setting the H DTL peak frequency.
For adjusting the gamma characteristics.
For adjusting the amount of offset in the black level.
For adjusting the amount of offset in the R pedestal.
For adjusting the amount of offset in the B pedestal.
Ignite SDC/HDC Robotic Camera Instruction Manual
S. GAIN1
:0.50
:+000
:+000
:+000