G/L Adjustment Settings; Detail Settings - GRASS VALLEY Ignite SDC Series Instruction Manual

Appendix B — SD (PAL) Camera Block

G/L Adjustment Settings

Detail Settings

72
Figure 43. G/L Adjustment Setting Submenu
Table 26. G/L Adjustment Settings
Selection
H Phase
SC Coarse
SC Fine
Figure 44. Detail Setting Submenu
Table 27. Detail Settings
Selection
Detail
H Detail Level H
V Detail Level H
H Detail Level L
V Detail Level L
Description
(-206 to +49) Horizontal phase can be adjusted when a genlock signal is
supplied.
(1, 2, 3, 4) Coarse adjustment of sub carrier phase can be made when a
genlock signal is supplied.
(-511 to +511) Fine adjustment of sub carrier phase can be made when a
genlock signal is supplied.
Description
(OFF, Low, High) Contour correction quantity can be selected. Detail set-
tings made using the Horizontal/Vertical Detail Level High/Low setting.
Detail level can be set in horizontal (H) and vertical (V) directions with the
Detail setting at High or Low.
Whichever the direction, H or V, the set level at High must be at least one
position higher than that
at Low.
(L+1 to +63)
(L+1 to +31)
(1 to H-1)
(1 to H-1)
Ignite SDC/HDC Robotic Camera Instruction Manual