Setting Soft Stops; Specifications - GRASS VALLEY Ignite SDC Series Instruction Manual

Setting Soft Stops

Specifications

Ignite SDC/HDC Robotic Camera Instruction Manual
Soft stops are software adjustable electrical limits for pan and tilt rotation.
• The default soft stops for both pan and tilt are ± 178º.
• If you install a prompter, you must set the tilt soft stops to ± 30º.
• You may also have to change default pan/tilt soft stops to prevent the
camera and/or prompter from contacting an obstacle near the selected
mounting location.
• To change the default soft stops, refer to the JSC-2300 SHOT Director
Robotics/Camera Controller Instruction Manual for procedures.
Robotic (pan/tilt head) specifications are listed in
Table 57. Robotics Specifications
Pan Range
Tilt Range
Tilt Range w/ Prompter
Pan and Tilt Speed
Acceleration
Accuracy - Repeatability
Maximum Load Capacity
Noise Rating (@ 30º/s)
Control
Control Distance
Control Outputs
Power
Weight
± 178º
± 178º
± 30º
90º/s
360º/s
30 arc seconds
(0.1" at 60') (1.4mm at 10m)
75.0 lbs. (35 kg)
<30 dBm @ 1m
Ethernet (10 Base-T)
Unlimited
4 (TTL)
120/240, 50/60 Hz, 100 W
20 lbs (9 kg)
Setting Soft Stops
Table 57.
109