Detail Menu - GRASS VALLEY Ignite SDC Series Instruction Manual

Detail Menu

Ignite SDC/HDC Robotic Camera Instruction Manual
The DETAIL menu is shown in
Table 39.
Figure 58. DETAIL Menu
** DETAIL (1/2) **
DETAIL :ON
TOTAL DTL LEVEL :+00
H DTL LEVEL :11
CRISP :02
LEVEL DEPENDENT :2
PEAK FREQUENCY :10
KNEE APERTURE :ON
KNEE APE LEVEL :3
Table 39. DETAIL Menu Selections
Selection
DETAIL [OFF, ON]
TOTAL DTL LEVEL [–31 to +31]
H DTL LEVEL [0 to 63]
CRISP [0 to 31]
LEVEL DEPENDENT [0 to 15]
PEAK FREQUENCY [00 to 31]
KNEE APERTURE [OFF, ON]
KNEE APE LEVEL [0 to 5]
SLIM DETAIL [OFF, ON]
DETAIL(+) [–31 to +31]
DETAIL(–) [–31 to +31]
DETAIL CLIP [0 to +63]
DETAIL SOURCE
[(G+R)/2, (G+B)/2, (2G+B+R)/4,
(3G+B)/4, R, G]
Figure 58. Menu selections are described in
** DETAIL (2/2) **
SLIM DETAIL :OFF
DETAIL (+) :+00
DETAIL (-) :+00
DETAIL CLIP :00
DETAIL SOURCE :(G+R)/2
Description
For turning all the detail functions ON or OFF.
For setting the H DTL and V DTL levels.
For setting the H DTL level.
For setting the noise elimination level of the detail signals.
For removing the detail in the dark areas.
For setting the H DTL peak frequency.
For turning the emphasizing of the outlines for the high-brightness areas
ON or OFF.
For adjusting the knee aperture level.
For setting the detail more finely at ON.
For adjusting the detail gain in the + direction.
For adjusting the detail gain in the – direction.
For minimizing the glare caused by adding too much detail as a result of a
detail clip adjustment.
For setting the ratio of the RGB signal components which create the detail.
Menu Selections
87