Robotic Pan/Tilt Head Assembly - GRASS VALLEY Ignite SDC Series Instruction Manual

Section 2 — Installation

Robotic Pan/Tilt Head Assembly

24
Note Ignite SDC/HDC robotic cameras are suitable for inverted mounting.
1. Check the selected camera location to ensure that there is enough
clearance (Figure 5) for the fully assembled camera, prompter, and
cables to pan and tilt without obstruction.
If necessary, you can limit pan and/or tilt movement by adjusting the
pan/tilt head soft stops via the SHOT Director controller. Refer to the
JSC-2300 SHOT Director Robotics/Camera Controller Instruction
Manual.
Figure 5. Clearance Diagram
2. On the stationary ring at the top of the pedestal mount
the zero-degree (pan) position labeled FRONT. Point the FRONT label
in the direction that best reflects the center of travel in which the camera
will be used (usually the center of the room).
Figure 6. Robotic Pan/Tilt Head Assembly
Front
Camera mount
L-bracket
8" Pedestal
mount
Diameter: 24" (0.61 m)
48" (1.22 m) with prompter
Robotic
pan/tilt
head
Zero degree
(Pan)
reference
Ignite SDC/HDC Robotic Camera Instruction Manual
(Figure 6), locate