Color Setting - GRASS VALLEY Ignite SDC Series Instruction Manual

Robotic camera
Table of Contents

Advertisement

Appendix A — SD (NTSC) Camera Block

Color Setting

46
Brightness Settings
Table 4.
Selection
Manu Gain Up
Pedestal
Figure 20. Color Setting Submenu
Table 5. Color Settings
Selection
Chroma Level
Flesh Tone
White Bal
ATW Speed
Description
Manual setting is possible only when the Auto Gain Up setting is "OFF".
0 dB: 0 dB should be selected in normal cases.
1 dB - 30 dB: Use this range if sufficient video output cannot be obtained
even when the lens iris is opened in shooting dark scenes.
N/Eye L (Night Eye L): Use this mode if sufficient video output can not be
obtained even if 30 dB gain up should be selected.
N/Eye H (Night Eye H): Use this setting if it is not possible to achieve a sat-
isfactory video output even at the Night Eye L setting.
(-150 to +150) The black level (pedestal) of the luminance (Y) signal can
be set. Used in adjusting the black levels of two or more cameras.
Description
(-3 to +3) Chroma Level can be decreased or increased to any of three lev-
els each.
(-3 to +3) Skin color can be decreased or increased to any of three levels
each.
ATW: The white balance is automatically adjusted to be always right.
AWC A, AWC B: Once the white balance is adjusted with the ITEM/
AWC switch on the back of the camera, it is no longer necessary to
set the white balance again if you simply select AWC A or AWC B,
provided that the camera is used under the same conditions. Fine
color adjustment can be made after setting AWC by red/blue gain
adjustment in user mode.
P SET 3200 K: The white balance is adjusted to 3200 K illumination.
P SET 5600 K: The white balance is adjusted to 5600 K illumination.
(Slow 2, Slow 1, Mid, Fast 1, Fast 2) ATW Speed can be set.
Ignite SDC/HDC Robotic Camera Instruction Manual

Advertisement

Table of Contents
loading

Table of Contents