G/L, Color Bar Settings; Detail Settings - GRASS VALLEY Ignite SDC Series Instruction Manual

G/L, Color Bar Settings

Detail Settings

Ignite SDC/HDC Robotic Camera Instruction Manual
Figure 26. G/L Color Bar Setting Submenu
Table 11. G/L Color Bar Settings
Selection
H Phase
SC Coarse
SC Fine
Color Bar Set
Color Bar Set2
Figure 27. Detail Setting Submenu
Table 12. Detail Settings
Selection
Detail
H Detail Level H
V Detail Level H
Description
(-206 to +49) Horizontal phase can be adjusted when a genlock signal is
supplied.
(1, 2, 3, 4) Coarse adjustment of sub carrier phase can be made when a
genlock signal is supplied.
(-511 to +511) Fine adjustment of sub carrier phase can be made when a
genlock signal is supplied.
(0.0 IRE, 7.5 IRE) The setup level of color bar can be adjusted.
(0.0 IRE, 7.5 IRE) Set to 0.0 IRE for the SDI card.
Description
(OFF, Low, High) Contour correction quantity can be selected. Detail set-
tings made using the Horizontal/Vertical Detail Level High/Low setting.
Detail level can be set in horizontal (H) and vertical (V) directions with the
Detail setting at High or
Low.
Whichever the direction, H or V, the set level at High must be at least one
position higher than that
at Low.
(L+1 to +63)
(L+1 to +31)
Menu Selections
53