Pre-Integration Tasks - Polycom ATX 200 Integrator Manual

Pre-Integration Tasks

Polycom, Inc.
Electronic Components:
Install the codecs and the System Controller
1
Install the speakers
2
Install the microphones
3
Install the Polycom Touch Control or the Crestron Touch Panel
4
Attach the serial number label
5
Connect the cables
6
ATX Software Configuration:
Perform the HDX out-of-box setup
1
Upgrade and activate the HDX software
2
Perform the software configuration as described in the Polycom Immersive
3
Telepresence (ITP) Administrator's Guide (part number 3725-26945-005)
Configure the HDX passwords
4
Display and Camera Configuration:
Configure the display settings
1
Prepare for the camera alignment
2
Align the cameras for the presets
3
Match the cameras for color and brightness
4
Configure the audio
5
Measure the room lighting
6
Check the display behavior when calling and hanging up
7
Before beginning the integration, you should:
Inspect the site:
1
Locate the equipment boxes and the room in which you will install the
a
ATX system.
Review Appendix A
b
installation.
Make sure that you are familiar with the customer's protocols and
2
procedures for security and safety.
to help determine if the room is ready for the
Integration Overview
1–3