Figure 5-16 Camera Control Screen - Polycom ATX 200 Integrator Manual

Polycom ATX Integrator's Guide
5 - 20
Do not pan, tilt, or zoom the other cameras at this point.
3
Open the camera controls for the camera attached to codec 2 and select 2
4
from the Select Camera drop-down list. This will result in the codec
sending black video.
Open the camera controls for the camera attached to codec 3 and select 2
5
from the Select Camera drop-down list. This will result in the codec
sending black video.
Make sure Preset 97 is selected and then press Set to save Preset 97 for all
6
the codecs.
Setting Preset 97 for an ATX 400 System
To set Preset 97 for an ATX 400 system:
On the Telepresence Tool Camera Alignment tab, select Preset 97.
1
Use the camera controls to adjust the pan, tilt, and zoom of the camera
2
connected to the Primary codec:
Pan, tilt, and zoom the camera to view the middle four seats and, if
a
desired, a portion of the adjacent seat on both sides.
Adjust the pan and zoom so that the two camera alignment marks on
b
the outside of the table are as close as possible to the edges of the
displayed video.
Figure 5-16 Camera Control Screen
Polycom, Inc.