Preparing For The Camera Alignment; Preparing For The Camera Alignment In An Atx 200 Room - Polycom ATX 200 Integrator Manual

Preparing for the Camera Alignment

Preparing for the Camera Alignment in an ATX 200 Room

Polycom, Inc.
To continue with the configuration of the ATX system, you must align the
cameras to point to particular locations in the room. Once you have aligned the
cameras, you can store the camera positions as presets in the Polycom HDX
codecs. Depending on what model of ATX system you have and who you are
calling, the system will activate the different presets to make the cameras point
to the appropriate location for that call. This section describes more about
camera alignment. The following section,
on page 5-15, describes how to store the camera positions into the proper
presets.
For ATX SDK, the integrator has the option to disable or override these
automatic camera presets.
The ATX 200 system has two codecs, two displays, and two cameras. As you
are seated in the room facing the displays, the displays are designated left and
right. Each camera is connected to a particular codec, and each codec is
connected to a particular display as described in the following table.
Camera
Camera Location
Camera-1 Left
(B1) display
Camera-2 Right
(B2) display
Configuring the Displays, Cameras, and Audio
Aligning the Cameras for the Presets
Display on
which Video
Appears Codec
Right display 1 (Primary)
Left display 2 (Secondary)
Seating Position
the Camera
Normally Points
to
1 and 2
3 and 4
5 - 5