Installing The Speakers - Polycom ATX 200 Integrator Manual

Polycom ATX Integrator's Guide

Installing the Speakers

3 - 2
To prepare the codecs and the System Controller for installation in a rack:
Attach each codec to an HDX 2U rack mounting tray using the hardware
1
supplied with the trays.
For more information, refer to the Setting up the Polycom HDX 2U Rack
Mounting Solution document (part number 1725-28249-002).
Install the codecs in the rack.
2
Install the C2ENET-1 Ethernet interface expansion card in the System
3
Controller, as described in the installation guide supplied with the card
(may not be needed for ATX SDK version 3.0.3).
Attach the mounting ears to the System Controller using the hardware
4
supplied with the System Controller.
For more information, refer to the documentation supplied with the
System Controller.
Install the System Controller in the rack.
5
You must connect speakers to the ATX system in order to hear audio. You can
provide your own speakers; however, Polycom recommends using the
Polycom Stereo Speaker kit, which provides excellent volume and rich sound
in large rooms. The Polycom Stereo Speaker kit (part number 2200-21969-120
for 120V power or 2200-21969-240 for 240V power) includes two speakers as
well as a subwoofer. If you choose to provide your own speakers, the speakers
should be equivalent to the speakers provided with the Stereo Speaker kit. For
more information about the Polycom Stereo Speaker kit, refer to
http://www.polycom.com.
To attach the speakers to the wall near the displays, Polycom recommends
using Omnimount universal speaker mounting brackets or an equivalent
mounting bracket.
To install the speakers:
Install one speaker mounting bracket on the wall to the left of the
1
displays and one on the wall to the right of the displays by following the
directions in the documentation provided with the mounting brackets.
Install the brackets so that the speakers will be centered as much as
possible with the side of the displays as shown in
Attach one speaker to each mounting bracket.
2
For better audio projection, angle the speakers 40 degrees inwards
3
towards the center of the table.
Figure 3-1.
Polycom, Inc.