Setting Preset 96; Figure 5-19 Aligning The Cameras For Preset 96 - Atx 200 System - Polycom ATX 200 Integrator Manual

Polycom ATX Integrator's Guide

Setting Preset 96

5 - 22
This section describes how to align the cameras for Preset 96 in an ATX 200 and
ATX 300 room.
Note that no alignment is necessary for Preset 96 for the ATX 400 system. For the
ATX 400, Preset 96 has the same alignment as Preset 99 and will be automatically
set by the Telepresence Tool.
Setting Preset 96 for an ATX 200 System
To set Preset 96 for an ATX 200 system:
On the Telepresence Tool Camera Alignment tab, select Preset 96.
1
Use the camera controls to adjust the pan, tilt, and zoom of each camera:
2
Pan, tilt, and zoom the camera to view the four seats.
a
Adjust the tilt so that the top edge of the table aligns with the blue line
b
at the center of all screens as shown in
Blue lines
Figure 5-19
After all cameras are aligned, make sure Preset 96 is selected and then
3
press Set to save Preset 96 for all the codecs.
Setting Preset 96 for an ATX 300 System
To set Preset 96 for an ATX 300 system:
On the Telepresence Tool Camera Alignment tab, select Preset 96.
1
Use the camera controls to adjust the pan, tilt, and zoom of each camera:
2
Pan, tilt, and zoom the camera to view the middle four seats and, if
a
desired, a portion of the adjacent seat on both sides.
Aligning the Cameras for Preset 96 — ATX 200 System
Figure 5-20.
Polycom, Inc.