Troubleshooting - Kyocera KM-S4850W Operation Manual

CHAPTER 11 TROUBLESHOOTING

9. Troubleshooting

Refer to the following chart if trouble occurs. If trouble persists, contact your service representative.
TROUBLE
The main power switch is on but
nothing is displayed on the
operation panel.
The original is set, but a copy is
not made.
The copy is blank.
Paper jams often.
Copy image is skewed.
Copy image is shifted to either
side (widthwise)
11-18
CHECK POINT
Is the power plug inserted
securely into the outlet?
Is there a message on the
operation panel?
Was the original inserted face
down?
Are there wrinkles or folds in the
paper?
Is there any jammed paper or
are there other pieces of paper
remaining inside the machine?
Is the paper setting method
proper?
Is vellum used?
Was the original fed straight?
Is inclination adjustment set?
Are the original guides properly
set in accordance with the
original size indications on the
original table?
Is the paper roll installed
properly into the roll unit?
Was the paper fed properly in
the bypass mode?
Was the image shift function
set?
PROCEDURE
Insert the power plug securely into the outlet.
Check the proper procedure for the displayed
message and perform accordingly.
Insert the original face down.
Remove the portion of the paper roll that contains the
wrinkles or folds.
Remove them by following the appropriate procedure.
Check the paper setting method.
The leading edge may have been damaged.
Pull out the paper roll until the damaged portion
comes out and then cut it before using it.
Set the original referring to "G Setting the original with
precision".
Disable the inclination adjustment.
Align the original guides with the original size
indications and then insert an original.
Align the flange guide positions with the appropriate
size labels.
Adjust the bypass guides to the paper size and then
insert the copy paper.
Cancel the image shift function.
PAGE
–
11-1
3-2
11-14
11-11
3-6
–
3-3
6-1
3-2
3-6
4-8
5-5