CHAPTER 11 TROUBLESHOOTING
1
Open the front cover.
2
Grasp the handles A of the roll unit to unlock the unit and
pull out the roll unit until it stops.
A
3
Grasp the flange and rewind the paper roll.
4
If there is any wrinkled or folded area, remove it with a
cutting knife or scissors.
11-14
A
5
Grasp both of the paper roll insertion latches 3 and open
the paper roll insertion cover 4.
3
6
Insert the leading edge of the paper back under the paper
roll insertion guide and pull the edge out approximately 1/2"
[10 mm] from the guide as shown in the illustration.
7
Grasp both of the paper roll insertion latches and close the
paper roll insertion cover.
IMPORTANT
• If the paper roll that has been set is slack, grasp the flange and
rewind the paper roll to clear the slack. If not, paper may be fed
obliquely.
4
3