Paper Roll Cut Length Selection; Synchronized Cut; Standard Cut - Kyocera KM-S4850W Operation Manual

CHAPTER 4 BASIC COPYING

5. Paper Roll Cut Length Selection

(1) Synchronized cut

Paper is cut based on the length of the original and the magnification
ratio.
The minimum cut length by synchronized cut is 11" [279 mm]. Even if
the copy image length is less than 11" [279 mm] due to reduction, a
blank area will be added in the trailing edge of the paper and paper
will be cut in length of 11" [279 mm].
1
Press the Cut Size key.
(Inch)
2
Ensure that "Synchronized cut" ["Synchronized"] is selected.
(Inch)
(Metric)
3
Press the OK key.
The machine will return to the basic screen.
4-6
(Metric)

(2) Standard cut

Paper is cut in length of standard size or in a length that has been
registered. The following lengths can be selected.
G Cut size (inch machine)
(Architecture) (Engineering)
48" 44"
36" 34"
24" 22"
18" 17"
12" 11"
User 1 (40") User 1 (40")
User 2 (80") User 2 (80")
G Cut size (metric machine)
(A sizes)
1,189 mm
841 mm
594 mm
420 mm
297 mm
User 1 (1,000 mm at default setting)
User 2 (2, 000 mm at default setting)
* Architecture or Engineering for inch machine and A sizes or B sizes
for metric machine can be selected using "# Standard size set".
(Page 7-3)
For user 1 and user 2, any cut size can be registered. See "4 Cut
size register". (Page 7-4)
1
Press the Cut Size key.
(Inch)
(B sizes)
1,030 mm
728 mm
515 mm
364 mm
User 1 (1,000 mm at default setting)
User 2 (2,000 mm at default setting)
(Metric)