Kyocera KM-S4850W Operation Manual page 92

CHAPTER 9 SET-UP (SCANNER)
Use the N and M cursor keys to move the arrow (e) to
9
"OFF".
14
Press the Enter key.
15 The entered IP address will be displayed to the right of the
"IP address" listing.
If you do not need to make any revisions to the IP address,
use the same procedure in order to set the Subnet mask,
Gateway and WINS server information.
16 Once you have completed all of the required settings, use
the N and M cursor keys to move the arrow (e) to
"Default/back manager" and then press the Enter key.
Then use the N and M cursor keys to move the arrow (e)
to "End" and press the Enter key once again.
9-4
G DHCP sever setting
If you use a DHCP server to assign the IP address of this machine,
perform this procedure in order to enable the DHCP server.
1 Press the * / Language key.
2 Use the N and M cursor keys to move the arrow (e) to
"Default set/manager".
3
Press the Enter key.
4 Use the numeric keys to enter your PIN code. (The factory
default code is "4850".)
5 Use the N and M cursor keys to move the arrow (e) to
"Printer setting".
6 Press the Enter key.
7 Use the N and M cursor keys to move the arrow (e) to
"DHCP server".
8 Press the Enter key.
9 If DHCP server setting is "OFF", use the N and M cursor
keys to move the arrow (e) to "ON".
*The present setting is indicated by a ">" mark.
*The DHCP server default setting is "OFF" .
10 Press the Enter key.
11 Once you have completed all of the required settings, use
the N and M cursor keys to move the arrow (e) to
"Default/back manager" and then press the Enter key.
Then use the N and M cursor keys to move the arrow (e)
to "End" and press the Enter key once again.