Parallel Port Setup; Network Protocol Setup - Kyocera Ci1000 Operating Instructions Manual

6

6-7 Network Protocol Setup

Parallel Port Setup

In addition to receiving print jobs over Ethernet or Token Ring, the printer can
receive print jobs from a computer through its high speed parallel port. If no
network card is installed, the printer must be connected to a computer via the
parallel port.
PARALLEL PORT
OFF/ON [ON]
Use this option to enable printing through the parallel port.
I/O TIMEOUT (SEC)
15-300 SECONDS [15]
If parallel printing is enabled, use this option to specify how long the printer waits
without receiving data from the parallel port before deciding that the current job
is complete. During the timeout, the printer cannot receive new jobs through the
parallel port, but it continues to receive network print jobs.
IGNORE EOF
YES/NO [YES]
This option appears only if is set to . Use this option to specify
PARALLEL PORT ON
that the printer should ignore end-of-file (EOF) messages in a file. To print
PostScript files in binary format (not ASCII), this option must be set to .
YES
When this option is set to , the printer uses the value you entered for the
YES
parallel port timeout to determine when it has reached the end of the file.
Network Protocol Setup
Network Protocol Setup options are used to specify and setup TCP/IP Ethernet,
TCP/IP Token Ring, AppleTalk, and IPX (Novell) network protocols.
TCP/IP Setup
TCP/IP-ETHERNET
YES/ NO [NO]
Select YES if you have a TCP/IP network connected to the printer over Ethernet
cabling.