Token Ring Setup - Kyocera Ci1000 Operating Instructions Manual

6
6-6 Setup from the Control Panel and WebSetup

Token Ring Setup

TOKEN RING
ON/OFF [ON]
Select to enable Token Ring network communication.Token Ring options
ON
appear only if an optional Token Ring card is installed.
TR SPEED
AUTO/4 M BPS/16 M BPS [AUTO]
Select
AUTO
the Token Ring network, or optionally specify the speed of your Token Ring
network.
MAX. FRAME SIZE
0.5K/1K/2K/4K [4K]
Use the arrow buttons to select a maximum frame size for Token Ring
communication.
The Token Ring frame size must be no greater than the frame size used by
N :
OTE
any router or Novell file server on the network.
SOURCE ROUTING
ON/OFF [OFF]
Select to allow the packet to travel to its destination through routers on the
ON
network. The packet's source dictates the route that the packet will take.
REQ ALL ROUTE
ON/OFF [ON]
If source routing is enabled, select
broadcast the presence of the printer, enabling packets from clients on the
network to travel to the printer by any route.
RESP ALL ROUTE
ON/OFF [ON]
If source routing is enabled and
routers on the network to broadcast the presence of clients to the printer, enabling
packets from clients on the network to travel to the printer by any route.
to automatically detect the speed at which data can be transferred over
ON
REQ ALL ROUTE
to allow all routers on the network to
is set to select
ON
to allow all
YES