System Setup - Kyocera Ci1000 Operating Instructions Manual

6
6-2 Setup from the Control Panel and WebSetup
4. To select an option, press Enter.
Repeat steps 3 and 4 to continue accessing other options.
5. To exit the Setup menus at any time, press the Cancel button.

System Setup

The System Setup menus enable you to specify information about the printer.
This section describes first-time setup if no password has been set. (Default values,
where applicable, are shown in square brackets.)
SYSTEM SETUP
To advance to the
[
PRINTER NAME
Ci1000
Use this option to give the printer a name. The printer name can be up to 16
characters.
PRINT START PAGE
YES/NO [YES]
Use this option to specify whether the printer should print a start page when it
restarts to verify that it is working properly. The Start page contains such
information as: printer name, enabled network protocols, amount of memory
installed, and options installed on the printer.
The following two options are available only on disk based systems with a
32 32
minimum of 32MB of memory.
PUBLISH PRINTD Q
YES/NO [YES]
Use this option to enable recently printed jobs to be stored on the printer. The
Printed queue makes it convenient to reprint those jobs.
JOBS TO SAVE
1-99 [10]
This option appears only if
specify the number of jobs to be stored in the Printed Queue.
screen, press Enter.
PRINTER NAME
]
PUBLISH PRINTD Q
is set to . Use this option to
YES