Chapter 4: Installing Macintosh Software; General Steps For Installing Macintosh Software; Installing Macintosh Printing Software - Kyocera Ci1000 Operating Instructions Manual

4

4-1 General steps for installing Macintosh software

Chapter 4:
Installing
Macintosh
Software
This chapter describes installing printer driver software and setting up printing on
a Macintosh computer. Instructions for setting up additional software provided
on the User Software CD are included at the end of this chapter.
Serial port printing from Macintosh computers is not supported by the Ci1000
Color Printer. For instructions on how to connect your printer to a network, see
Chapter 1 of Operating Instructions.
General steps for installing Macintosh software
The general steps for installing the Ci1000 software from the CD and setting up
printing on a Macintosh computer are:
• Enable Ethernet and AppleTalk from the printer's panel
See "Network Protocol Setup" on page 6-7 of Operating Instructions for details.
• Enable AppleTalk in the Chooser on the Macintosh.
• Install the Adobe PostScript Printer Driver
• Setup the Ci1000 Color Printer in the Chooser
• Copy additional color reference files, sample files, and font files from the User
Software CD as needed
Initial Printer Setup, specifically, setting the printer's IP address, as well as
N :
OTE
its gateway, subnet mask, and password (if they are used), must be performed
from the printer's front panel. Additional options may be specified using the front
panel or Fiery WebSetup.

Installing Macintosh printing software

To set up the Ci1000 as a PostScript printer, you must install the PostScript
printer description file (PPD) that corresponds to your printer and the Adobe
PostScript Printer Driver (version 8.5.1 supports PostScript 3) provided on the
User Software CD. Printer drivers provide a way to communicate information on
print jobs between your applications and the Ci1000 (and any other PostScript
printer connected to your computer).