Kyocera Ci1000 Operating Instructions Manual page 189

8
8-5 Installing a hard disk drive
T
O INSTALL A NEW HARD DISK DRIVE
1. Unpack the new hard disk drive. With the rounded side down, place the drive on a
2. Place the video controller board on a stable surface.
3. Orient the hard disk drive on the video controller board so the hard disk
4. Slide the hard disk in as shown by the arrow, and attach it firmly to the connector.
Hard disk
5. Make sure that the four holes in the hard disk are aligned with the corresponding
6. Put each of the four washers on each of the four screws.
:
flat surface or on the palm of your hand.
Do not touch the drive with magnetic objects or place objects sensitive to magnets
near the drive.
connector (1) faces the connector on the video controller board (2).
Do not connect the leftmost four pins of the hard disk connector (3).
N :
OTE
holes in the video controller board.
You must insert each of the screws into a washer before you use the screws
N :
OTE
to attach the hard disk to the video controller board.
1
3
2