Table of Contents
Advertisement
Diagnostics
Running diagnostic programs
AMIDiag Menus
© Copyright IBM Cor p. 2001
This section provides basic troubleshooting information to help you resolve some
common problems that might occur with your server.
If you cannot locate and correct the problem using the information in this section,
refer to the "Symptom-to-FRU index" on page 227.
Note: For optimum display update performance, it is recommended that Console
Redirect be set to "disabled" before running diagnostics. For information on
how to disable Console Redirect, see Table 8 on page 96.
To run the AMIDiagnostic program complete the following:
1.
Insert the LS120 diskette containing the diagnostic program into the diskette
drive.
2.
Boot the system to the EFI shell.
3.
Select fs0: as the default drive by typing
fs0:
and pressing Enter.
4.
Start the diagnostic program by typing amidiag and pressing Enter.
5.
Use the arrow keys to select the test.
6.
Press Enter to run the test.
The AMIDiag main menu is shown below.
Select a menu options by pressing the ↑ or ↓ keys and pressing <Enter> when the
menu is highlighted. Press the → or ← keys to display a different AMIDiag menu.
15
Advertisement
Table of Contents
