Table of Contents
Advertisement
LS120 FD diskette drive installation
CD-ROM drives
CD-ROM drive removal
174
Hardware Maintenance Manual: xSer ies 380
Loosen the thumbscrew ( 2 ) found at the rear of the drive carrier assembly.
3.
4.
Slide the drive carrier assembly toward the rear of the chassis so that the front
part of the drive clears the opening in the chassis and remove.
Depress the tab ( 4 ) and spread the two halves of the drive carrier assembly
5.
apart so that the ends of the drive cable adapter PCB come out of their respective
slots ( 5 ).
6.
Unplug the drive cable adapter PCB from the back of the drive.
7.
Remove the drive from the two halves of the drive carrier assembly.
8.
Place the drive in an antistatic protective wrapper if you are not reinstalling the
same drive.
Complete the following actions to install an LS120 FD diskette drive.
1.
Remove the new drive from its protective wrapper, and place it component-side
down on an antistatic surface.
2.
Plug the drive cable adapter PCB into the rear of the drive.
3.
When locating the two halves of the drive carrier, be sure that following
conditions are met:
•
The end with the thumbscrew is oriented toward the rear of the drive.
•
The two ends of the drive cable adapter PCB are inserted into the slots in the
carrier.
•
The four metal tabs (two on each half of the drive carrier) are aligned with the
holes in the drive.
•
Ensure that the tab is locked.
4.
Pick up the entire drive carrier assembly, being careful that you keep the pieces
together, and place it on the chassis surface just inside the drive slot.
5.
Grasp the sides of the assembly and slide it forward such that the front part of the
drive comes through the opening in the chassis. Make sure that the thumbscrew
at the rear of the drive carrier assembly aligns with the hole in the surface of the
chassis.
6.
Tighten the thumbscrew at the rear of the drive carrier assembly.
7.
Install the drive's data and power cables into the cable adapter PCB.
8.
Install the top cover. See "Top cover installation" on page 170.
The CD-ROM Drive is housed in a two-piece drive carrier assembly. The drive carrier
assembly is accessible when the top cover is removed. The following sections
describe how to remove and install the drive.
Complete the following actions to remove the CD-ROM drive.
Note:
•
Read "Before you begin" on page 136.
•
Read "Safety information" on page 257 .
•
Read "Handling electrostatic discharge-sensitive devices" on page 260.
Advertisement
Table of Contents
