Table of Contents
Advertisement
Memory board DC-DC converters
Memory board DC-DC converter removal
190
Hardware Maintenance Manual: xSer ies 380
32
31
5.
Gently push the plastic ejector levers on the socket ends to the upright position.
6.
Repeat steps 2 on page 189 through 5. for each DIMM you want to install.
7.
Install the Processor/Memory complex as described in "Processor/memory
complex installation " on page 179.
The memory board DC-DC converters are located on the side of the
Processor/Memory Complex inside the system chassis. The server uses two
converters per memory board. You can access them by removing the
Processor/Memory Complex.
Note:
•
Read "Before you begin" on page 136.
•
Read "Safety information" on page 257 .
•
Read "Handling electrostatic discharge-sensitive devices" on page 260.
Complete the following actions to remove the memory board DC-DC converter:
1.
Remove the Processor/Memory Complex as described in "Processor/memory
complex removal" on page 177 .
2.
Orient the Processor/Memory Complex so that the side with the DC-DC
converters is toward you and facing upward.
A
Advertisement
Table of Contents
