IBM xSeries 380 Hardware Maintenance Manual page 103

Table 6. BIOS Setup Advanced Screen Menu Items.
Primary
Menu Item Menu Item
Boot Plug & Play O/S
Configuration
Reset
Config Data
Numlock
ADM
Graphics
Mode
Peripheral Serial Port A
Configuration
Serial Port B
Parallel Port
Mode
Onboard SCSI
Onboard NIC
Sub
Value
[No]
Yes
[No]
Yes
[On]
Off
[Disabled]
Enabled
[Auto]
Enable
Disable
[Auto]
Enable
Disable
[Auto]
Enable
Disable
[Bi-
directional]
Output
Only PP
ECP
[Enabled]
Disabled
[Enabled]
Disabled
Configures boot settings. If the operating system that runs on
the serv er supports plug and play operation, set this value to
Yes.
Resets the configuration data after a reboot operation.
Locks the number keypad.
Enables or disables the ADM graphics mode.
Determines Serial Port A configuration at boot time.
Auto causes the server to determine the Base I/O address and
interrupt to use for the port.
Enable requires you to supply the Base I/O address and the
interrupt value.
Disable causes the server to disable the port.
Determines Serial Port B configuration at boot time.
Auto causes the server to determine the Base I/O address and
interrupt to use for the port.
Enable requires you to supply the Base I/O address and the
interrupt value.
Disable causes the server to disable the port.
Determines Parallel Port configuration at boot time.
Auto causes the server to determine the Base I/O address and
interrupt to use for the port.
Enable requires you to supply the Base I/O address and the
interrupt value.
Disable causes the server to disable the port.
Defines the transfer mode for the Parallel Port.
Bi-directional allows data transfer to and from the server
Output Only allows data transfer from the server only.
EPP specifies Enhanced Parallel Port mode.
ECP specifies Enhanced Port mode.
Enables or disables the onboard SCSI.
Enables or disables the onboard NIC.
Description
Configuration
93