Table of Contents
Advertisement
CAUTION:
The power control button on the device and the power switch on the power
supply do not turn off the electrical current supplied to the device. The device
also might have more than one power cord. To remove all electrical current
from the device, ensure that all power cords are disconnected from the power
source.
2.
After the server shuts down, unplug both AC power cords to remove standby
power from the server.
3.
Remove the front bezel.
4.
Remove each hard disk drive from the drive bay by first grasping its handle and
depressing the drive locking tab ( 1 ), and then sliding the drive out of the bay.
FRU information (service only)
171
Advertisement
Table of Contents
