Table of Contents
Advertisement
2 on page 185 through 8 on page 186 describe the removal process for
either memory board.
2.
If desired, remove the DIMMs from the memory board you are removing as
described in "DIMMs" on page 187.
3.
Remove the DC-DC converters from the memory board as described in "Memory
board DC-DC converters" on page 190.
4.
Loosen the captive screws that secure both board clamps to the sides of the
memory board and lift them out of the Processor/Memory Complex ( 1 ).
5.
Loosen the two captive screws in the handle that spans the middle of the memory
board ( 2 ).
6.
Loosen the thumbscrew on the center bracket that locks the memory board
extraction levers down ( 3 ) and slide bracket out of the way of the extraction
levers.
FRU information (service only)
185
Advertisement
Table of Contents
