Hard Drive Bay Installation - IBM xSeries 380 Hardware Maintenance Manual

5.
6.

Hard drive bay installation

Complete the following actions to install a hard drive bay.
Note:
1.
172
Hardware Maintenance Manual: xSer ies 380
Remove the four #2 Phillips screws ( 1 ) from the top and bottom of the drive bay.
Grasp the bay by the Front Panel display housing and gently pull the drive out of
the chassis.
• Read "Before you begin" on page 136.
• Read "Safety information" on page 257 .
• Read "Handling electrostatic discharge-sensitive devices" on page 260.
Verify that the AC power cables have been disconnected from the chassis.
Statement 5
CAUTION:
The power control button on the device and the power switch on the power
supply do not turn off the electrical current supplied to the device. The device
also might have more than one power cord. To remove all electrical current
from the device, ensure that all power cords are disconnected from the power
source.