Table of Contents
Advertisement
Sideplane installation
PCI hot plug LED board
5.
Slide the Sideplane towards the front of the chassis. As you slide the board, keep
the front bottom edge of the board in contact with the carrier tray as the board is
rotated up and out of the chassis.
6.
Tilt the Sideplane up and out of the chassis.
7.
Remove the screws from Sideplane to separate it from its mounting plate.
Note:
•
Read "Before you begin" on page 136.
•
Read "Safety information" on page 257 .
•
Read "Handling electrostatic discharge-sensitive devices" on page 260.
Complete the following actions to install the sideplane:
1.
Connect the Sideplane to its mounting plate by tightening the mounting plate
screws.
2.
Lower the sideplane and tray assembly into the side of the chassis, and slide it
toward the rear of the chassis back into position. The front lower corner of the
board is the rotation point you should use when positioning the board into place.
3.
Tighten the captive thumbscrew on the sideplane to secure it to the chassis.
4.
Reinstall the T-Docking board as described in "T-Docking board installation" on
page 210.
5.
Reinstall the I/O Baseboard as described in "I/O baseboard installation" on page
199.
6.
Reinstall the Processor/Memory Complex as described in "Processor/memory
complex installation " on page 179.
The PCI Hot Plug LED board resides just on the inside of the top rear of the chassis.
This board enables PCI hot plug boards to be plugged into and out of the system
without it being shut down.
FRU information (service only)
201
Advertisement
Table of Contents
