Table of Contents
Advertisement
PCI hot plug LED board installation
Legacy I/O board
Legacy I/O board removal
7.
Carefully pull the PCI Hot Plug LED board away from the inside of the chassis
and place it on a clean ESD-protected work surface.
Note:
•
Read "Before you begin" on page 136.
•
Read "Safety information" on page 257 .
•
Read "Handling electrostatic discharge-sensitive devices" on page 260.
Complete the following actions to install the PCI hot plug LED board:
1.
Carefully place the PCI Hot Plug LED board on the inside back of the server
chassis. Position the board such that the four black pin receptacles line up with
their respective holes.
2.
Press the pins through the holes in the board and through their receptacles in the
chassis.
3.
Connect the cable to the PCI Hot-Plug LED Board.
4.
Attach the non-hot plug PCI adapter board cover to the chassis if necessary and
secure it with the screw.
5.
Close the rear part of the top cover and secure it by tightening the two
thumbscrews in the back.
The Legacy I/O board is plugged into the I/O Baseboard in the rear of the chassis. It
is accessible only when you remove or lift the non-hot plug PCI adapter board cover.
Note:
•
Read "Before you begin" on page 136.
•
Read "Safety information" on page 257 .
•
Read "Handling electrostatic discharge-sensitive devices" on page 260.
Complete the following actions to remove the Legacy I/O board:
Important: •
When replacing the T-Docking board or the I/O Legacy board, the
BIOS and firmware levels must be upgraded to the latest level.
•
Replacing the Legacy I/O board may cause loss of boot record data.
See "Saving boot records" on page 87.
1.
Label and disconnect all peripheral cables attached to the Legacy I/O board's
back panel on the back of the system.
2.
Loosen the two thumbscrews in the back of the chassis that secure the rear cover.
3.
Lift the rear cover to expose the non-hot plug PCI adapter board cover.
FRU information (service only)
203
Advertisement
Table of Contents
