Table of Contents
Advertisement
MITSUBISHI CNC
4 Connection
4.5 Connection of MITSUBISHI CNC Machine Operation Panel
(Note)
In this chapter "MITSUBISHI CNC Machine operation panel" is shorten to Machine operation panel.
Connect Machine operation panel A to the remote I/O unit I/F of control unit or operation panel I/O unit.
- Machine operation panel A (RIOIN) - cable (FCUA-R211 or SH41) - control unit (RIO1)
- Machine operation panel A (RIOIN) - cable (FCUA-R211 or SH41) - operation panel I/O unit (RIO3)
When supplying power to control unit from Machine operation panel A, the following connection is necessary.
- Machine operation panel A (DCOUT) - cable (G071) - control unit (DCIN)
Connect Machine operation panel B to Machine operation panel A and control unit as follows.
- Machine operation panel B - cable (G460) - Machine operation panel A (SUBP)
- Machine operation panel B - cable (F120) - control unit (EMG)
[When connecting to operation panel I/O unit (RIO3)]
HN232 Card
(Placed on the back of the panel A)
F070
DCIN
DC24V
FG
Machine operation panel A
(FCU7-KB921)
<Related items>
Cable drawing: "Cable: F120 Cable"
"Cable: FCUA-R211 Cable"
"Cable: G460 Cable"
"Cable: SH41 Cable"
"Cable: G011 Cable"
Connector pin assignment: "General Specifications: Operation panel I/O unit" (RIO3 connector/DCIN connector/
DCOUT connector/ RIOIN connector/SUBP connector/EMG connector/CG71 connector)
144
Only when relaying the power G071
DCOUT
RIOIN
FCUA-R211/SH41
SUBP
KEYSW
EXT
G460
G054
Operation panel I/O Unit
Machine operation panel B
(FCU7-KB926)
DC24V
DCIN
RIO3
CG71
CG71
G011
EMG
F120
When directly providing
the power
F070
Control Unit
Advertisement
Table of Contents
