Connecting A Water Temperature Sensor (Optional) - Intermatic PE650 Installation And User Manual

Connecting a Water Temperature
Sensor (optional)
The Intermatic I-Wave PE650 and PE950
wireless components can monitor water
temperature with use of an Intermatic Water
Temperature Sensor (PA122).
The Intermatic water temperature sensor
(PA122) is required to monitor either or
both the pool and spa water temperatures,
depending on the position of the diverter
valves, and completes the circuit allowing
you to control the heater with the Handheld
Transceiver (PE950). Only an Intermatic
(PA122) Water Temperature Sensor will work
with the Panel Mount Transceiver (PE650).
In a pool/spa application, a Valve/Pump
Mechanism (P4243ME) can be installed to
automatically control the motorized diverter
valves, and enable both the pool and spa
water temperature set points on the handheld
transceiver (PE950).
If there is only a pool or spa to control, then
a Valve/Pump Mechanism (P4243ME) is not
required and only the SET Pool Temperature
Set Point will be functional on the Handheld
Transceiver (PE950)
Disconnect power when connecting the
water temp sensor. Follow instructions that
came with the water temperature sensor for
mounting it to the system's plumbing. Tips
and a wiring diagram, which follow, will
help with the installation.
Install Panel-Mounted Transceiver
Providing a brighter solution.™
9