Intermatic PE650 Installation And User Manual page 46

6
I-Wave PE950/PE650 Installation Guide
If it doesn't
work
Verify that
the Pool and
Spa Set point
on the Hand-
Held Remote
is set higher
than the
actual water
temperature
shown on its
display.
Verify that
the Fireman
switch
wires from
the Panel-
Mounted
Transceiver
are connected
properly to the
heater.
Verify heater
works
independently
of the control
system.
Reference/Procedure
1.
On the right hand side of the
display there should be a P
and S indicating the pool and
spa set temperatures. Press the
<ARROW> buttons to adjust the
set point so that it is higher then
the actual water temperature.
.
Verify that the word HEATING
appears at the bottom of the
display. This indicates that the
heater should be heating, if it is
working properly and the system
is wired and plumbed properly.
Identify your heater (see page 13)
and retrace your wiring to verify all
lines are connected properly.
1.
Remove all wires from the control
to the heater and hook up the
heater system as a stand-alone
unit.
.
Verify that the heater works with
its own thermostat.
Copyright © 2006 Intermatic, Inc.